PenHolder

This project has a Penholder included on it. This penholder is made for a marker with a diameter of ~18mm and went trough multiple itterations.

It is attached by pressing onto the board into the middle circle and pressing so the notches to the side click into place. the marker should be stable within the holder. Note that the marker pottentially won't fit with the cap on so make sure to remove the cap before inserting the marker.

The GCode that was used is made for the Ender 3 Pro v2 Neo printer

Settings: - No support - Infill density of 20% and line density of 6 mm - Layer height of 0.2 - Nozzle 0.4mm - Speed: 50mm/s - Material: PLA

The GCode,Stl and Scad file are found at: physical-design\penholder\PenHolderDesigns\Final version

The penholder is made to fit within the hole on the cart there is room available of smaller variants that are made for smaller sized pens/markers.